Programming manual
326
CNC 8070
12.
CYCLE EDITOR
Profile
(SOFT V02.0X)
314
Spindle turning direction (icon).
Clockwise with icon
(a)
.
Counterclockwise with icon
(b)
.
Basic operation:
1. It selects the roughing tool and starts the spindle in the requested
direction.
2. Rapid movement (G0), up to the XY point and the safety plane (Zs).
Depending on the starting plane, it first moves in XY and then in
Z or vice versa.
3. Rapid movement (G0) up to the approach plane.
4. Roughing operation.
It is carried out in layers until the total depth is reached.
4.1. Penetration "I" at feedrate "Fz".
4.2. Profile milling at feedrate "F".
If it was defined with tool radius compensation, the milling
is carried out at a "δ" distance from the wall.
4.3. Rapid withdrawal (G0) up to the safety plane (Zs).
4.4. Rapid movement to the starting point X1Y1.
5. It selects the finishing tool and starts the spindle in the requested
direction.
6. Finishing operation.
7. Penetration to the bottom at feedrate "Fz".
• Profile milling at feedrate "F".
8. Rapid withdrawal (G0) up to the safety plane (Zs).
F Milling feedrate.
S Spindle speed.
T Finishing tool.
If programmed T=0, there is no finishing.
D Tool offset.
(b)(a)
To Next Page
Loading...
