Programming manual
CNC 8070
CYCLE EDITOR
Slot milling
12.
(SOFT V02.0X)
315
12.20 Slot milling
The way the roughing and finishing blocks of this cycle are joined will
be the one previously set by the user with the instructions #HSC, G5,
G50 or G7. We recommend to use #HSC or G5 controlling the shape
of the corner with the instruction #ROUNDPAR.
Geometric parameters:
Type of slot milling (icon).
There are 6 possible types.
4 for slot mill each corner of the part.
2 for milling a slot across the part.
Roughing parameters:
The roughing operation leaves the following finishing stocks:
X, Y Corner where the slot is to be milled.
L, H Slot dimensions.
The sign indicates the orientation referred to the XY point.
Z Part surface coordinate.
Zs Safety plane coordinate.
P Total depth.
το Angle, in degrees, between the slot and the abscissa axis. The
turn is carried out on the defined corner, X,Y point.
δ Finishing stock on the side walls.
To Next Page
Loading...
