Programming manual
326
CNC 8070
12.
CYCLE EDITOR
Slot milling
(SOFT V02.0X)
316
Both stocks are defined as finishing parameters.
The roughing operation defining parameters are:
Spindle turning direction (icon).
Clockwise with icon
(a)
.
Counterclockwise with icon
(b)
.
Machining direction (icon).
Clockwise with icon
(c)
.
Counterclockwise with icon
(d)
.
δz Finishing stock at the bottom of the pocket.
∆ Maximum milling pass or width.
The cycle recalculates the pass so that all the passes are
identical, with the same value as or smaller than the one
programmed.
If programmed with a 0 value, it assumes a value of 3/4 of the
diameter of the selected tool.
E Overshooting distance of the tool off the surface being milled.
Fz Penetration feedrate.
I Penetration step.
• If programmed with a positive sign (I+), the cycle
recalculates the step so all the penetrations are identical
with the same value as or smaller than the one programmed.
• If programmed with a negative sign (I-), the slot milling is
carried out with the given pass (step) except the last pass
that machines the rest.
In either case, the cycle limits the step to the cutting length
assigned to the tool in the tool table.
F Surface milling feedrate.
S Spindle speed.
T Roughing tool.
If programmed T=0, there is no roughing.
D Tool offset.
(b)(a)
(d)(c)
To Next Page
Loading...
