Programming manual
CNC 8070
CYCLE EDITOR
Random multiple machining
12.
(SOFT V02.0X)
325
12.25 Random multiple machining
The starting point is the cycle defining point.
The rest of the points (P2) to (P12) must be defined in the area for
multiple machining.
When not using all the points, define the first unused point with the
same coordinates as those of the last point of the profile.
Programming example:
The canned cycle defined at point X25, Y25 is to be repeated at the
rest of the points.
The canned cycle is defined at point (P1) X25, Y25
The rest of the points (P2) to (P7) must be defined in the area for
multiple machining.
Since there are only 7 points, you must define (P8) = (P7).
(P2) X 50 Y 25
(P3) X 100 Y 25
(P4) X 75 Y 50
(P5) X 50 Y 50
(P6) X 25 Y 75
(P7) X 100 Y 75
(P8) X 100 Y 75
To Next Page
Loading...
