Fagor CNC 8070 - Page 401



 Programming manual
CNC 8070
CNC VARIABLES
Related to general machine parameters
14.
(SOFT V02.0X)
367
RELATED TO SUBROUTINES PRG PLC INT
(V.)[n].MPG.TOOLSUB
Subroutine associated with "T" — — R
(V.)[n].MPG.REFPSUB
Subroutine associated with G74 — — R
(V.)[n].MPG.OEMSUB(1..10)
Subroutines associated with G180 through G189 — — R
(V.)[n].MPG.SUBPATH
Program subroutine path — — R
PROBE
PRG PLC INT
(V.)[n].MPG.PRB1MIN
Minimum probe coordinate along the abscissa axis R R R
(V.)[n].MPG.PRB1MAX
Maximum probe coordinate along the abscissa axis R R R
(V.)[n].MPG.PRB2MIN
Minimum probe coordinate along the ordinate axis R R R
(V.)[n].MPG.PRB2MAX
Maximum probe coordinate along the ordinate axis R R R
(V.)[n].MPG.PRB3MIN
Minimum probe coordinate along the axis
perpendicular to the plane
RRR
(V.)[n].MPG.PRB3MAX
Maximum probe coordinate along the axis
perpendicular to the plane
RRR