Programming manual
CNC 8070
CNC VARIABLES
Related to the programmed functions
14.
(SOFT V02.0X)
393
(V.)[n].G.PENDRPT and (V.)[n].G.PENDNR indicate the number of repetitions pending to execute. In
the first execution, its value is the programmed number of repetitions minus one and in the last one,
its value is zero.
These variables are read-only (R) synchronous and are evaluated during execution. They
correspond to linear and rotary axes.
Here is an example where the starting point is X0 and G100 X100 F100 has programmed . The value
of (V.)A.MEASIN.Xn is updated (refreshed) when probing with G101.
These variables are read-only (R) synchronous and are evaluated during block preparation.
These variables are read-only (R) synchronous and are evaluated during execution. These
variables correspond to linear and rotary axes; not to spindles.
These values are maintained during the execution of the program even when canceling manual
intervention.
BLOCK REPETITION PRG PLC INT
(V.)[n].G.PENDRPT
Number of pending repetitions with #RPT R R R
(V.)[n].G.PENDNR
Number of pending repetitions with NR R R R
PROBING (G100, G101, G102) PRG PLC INT
(V.)[n].A.MEAS.Xn
Measured value. Tool base coordinates R R R
(V.)[n].A.ATIPMEAS.Xn
Measured value. Tool tip coordinates R — —
(V.)[n].G.PLMEAS1
Value measured on the first axis of the channel. Tool tip
coordinates
R——
(V.)[n].G.PLMEAS2
Value measured on the second axis of the channel. Tool tip
coordinates
R——
(V.)[n].G.PLMEAS3
Value measured on the third axis of the channel. Tool tip
coordinates
R——
(V.)[n].A.MEASOF.Xn
Difference with respect to programmed point R R R
(V.)[n].A.MEASOK.Xn
Probing finished
"0" = No "1"= Yes
RRR
(V.)[n].A.MEASIN.Xn
Coordinate that includes measurement offset R R R
(V.)[n].G.PLMEASOKx
Probing on the plane axes completed R — —
V.A.MEAS.X = 95
V.A.MEASOF.X = -5
V.A.MEASOK.X = 1
PROBE
PRG PLC INT
(V.)[n].G.ACTIVPROBE
Number of the active probe R R R
MOVEMENTS IN MANUAL INTERVENTION
PRG PLC INT
(V.)[n].A.MANOF.Xn
Distance moved with G200 or inspection R R R
(V.)[n].A.ADDMANOF.Xn
Distance moved with G201 R R R
To Next Page
Loading...
