Programming manual
CNC 8070
STATEMENTS AND INSTRUCTIONS
Programming statements
15.
(SOFT V02.0X)
451
#SET OFFSET Limits
This instruction defines the upper and lower limits of the indicated axis,
within which the axes can be jogged during additive manual
intervention.
The programming format is:
#SET OFFSET [<lower>, <upper>] <Xn>
The limits are referred to the axis position. The lower limit must be less
than or equal to zero and the upper limit must be zero or greater than
zero.
#SYNC POS Synchronization
This instruction synchronizes the preparation coordinate with the
execution one and assumes the additive manual offset.
The programming format is:
#SYNC POS
This instruction sets the distance per handwheel pulse in a time period
equal to the CNC’s cycle time. If the feedrate required for this
movement exceeds the maximum set by the machine manufacturer,
the feedrate will be limited to this value and the axis moving distance
will be less than what has been programmed in the instruction.
Example: If a 5 mm move is programmed and the cycle time is 4 msec,
the resulting feedrate is 1250 mm/sec. If the maximum feedrate is
limited to 1000 mm/sec., the actual distance moved will be 4 mm.
i
Parameter Meaning
<lower> Lower limit.
<upper> Upper limit
<axis> Axis.
···
G01 X30 Y30 F550
N100 G201 #AXIS [Y] (Y axis manual interpolation)
N110 #SET OFFSET [-20,35] Y (Y axis limits)
N120 G01 X100 Y45 F400
···
To Next Page
Loading...
