Fagor CNC 8070 - Page 493



 Programming manual
CNC 8070
STATEMENTS AND INSTRUCTIONS
Programming statements
15.
(SOFT V02.0X)
459
• The optional <accel> parameter sets the influence of the
acceleration set with functions G130 and G131.
By default, it assumes a value of ·0·.
• The optional <move> parameter determines whether functions
G130, G131, G132 and G133 affect the G00 movements or not.
By default, it assumes a value of ·0·.
Value Meaning
0 Always applied.
1 Only applied in the acceleration stage.
2 Only applied in the deceleration stage.
Value Meaning
0 They affect the G00 movements.
1 They do NOT affect the G00 movements.