Programming manual
CNC 8070
PROBING CANNED CYCLES.
Tool calibration
16.
(SOFT V02.0X)
491
Once the wear measuring cycle has ended
It compares the measured value with the theoretical length assigned
in the table.
• If the maximum wear allowed is exceeded, it sets the "expired tool"
indicator and acts as follows:
• If the measurement difference does not exceed the maximum
allowed, it updates global arithmetic parameter P299 and the
values assigned to the tool offset selected in the tool table.
If the dimension of each edge was requested (parameter "N"), the
values will be assigned to global parameters P271 and the following
ones.
C0 It issues a "rejected tool" message and interrupts the
execution so the user may select another tool.
C1 The cycle replaces the tool with another one of the same
family.
P299 Measured length - theoretical length (L).
L Theoretical length (it maintains the previous value).
LW Measured length - theoretical length (L).
To Next Page
Loading...
