Programming manual
522
CNC 8070
16.
PROBING CANNED CYCLES.
Tool calibration
(SOFT V02.0X)
492
16.1.2 Measure or calibrate the radius of a tool.
It may be carried out with spindle stopped or climb cutting.
Programming
The programming format depends on the type of operation to be
carried out.
• Tool radius calibration:
#PROBE 1 B I2 J0 F K S N X U Y V Z W
• Measure the radius wear:
#PROBE 1 B I2 J1 F K S M C N X U Y V Z W
B Safety distance. It must be programmed with a positive value
greater than 0.
I Type of measurement or calibration.
Value Meaning
0 Length on the tool shaft.
1 Length on the tool tip.
2 Measure or calibrate the tool radius.
3 Tool length and radius.
If not programmed, the canned cycle will take the value of "I0".
J Operation to be carried out.
Value Meaning
0 Tool calibration.
1 Wear measurement.
If not programmed, the canned cycle will take the value of "J0".
F Probing feedrate.
K Probe side used.
Value Meaning
0 On the X+ side.
1 On the X- side.
2 On the Y+ side.
3 On the Y- side.
If not programmed, the canned cycle will take the value of "K0".
S Tool direction and turning speed. The chosen direction must
be opposite to the cutting direction (Positive if M3 and negative
if M4).
If not programmed, the cycle assumes the value "S0"
(calibration with spindle stopped).
M Maximum radius wear allowed.
If not programmed, the cycle assumes the value "M0" (the tool
will not be rejected due to length wear).
To Next Page
Loading...
