Programming manual
522
CNC 8070
16.
PROBING CANNED CYCLES.
Tool calibration
(SOFT V02.0X)
494
16.1.3 Measure or calibrate the radius and length of a tool.
It may be carried out with spindle stopped or climb cutting.
Programming
The programming format depends on the type of operation to be
carried out.
• Tool radius calibration:
#PROBE 1 B I3 J0 F K D S N X U Y V Z W
• Measure the radius wear:
#PROBE 1 B I3 J1 F K L D S M C N X U Y V Z W
B Safety distance. It must be programmed with a positive value
greater than 0.
I Type of measurement or calibration.
Value Meaning
0 Length on the tool shaft.
1 Length on the tool tip.
2 Measure or calibrate the tool radius.
3 Tool length and radius.
If not programmed, the canned cycle will take the value of "I0".
J Operation to be carried out.
Value Meaning
0 Tool calibration.
1 Wear measurement.
If not programmed, the canned cycle will take the value of "J0".
F Probing feedrate.
K Probe side used.
Value Meaning
0 On the X+ side.
1 On the X- side.
2 On the Y+ side.
3 On the Y- side.
If not programmed, the canned cycle will take the value of "K0".
L Maximum length wear allowed.
If not programmed, the cycle assumes the value "L0" (the tool
will not be rejected due to length wear).
D Radius or distance referred to the tool shaft where it is probed.
If not programmed, the cycle assumes the tool radius value.
To Next Page
Loading...
