Programming manual
522
CNC 8070
16.
PROBING CANNED CYCLES.
Tool calibration
(SOFT V02.0X)
496
Once the wear measuring cycle has ended
It compares the measured length with the theoretical one assigned in
the table.
• If the maximum wear allowed is exceeded, it sets the "expired tool"
indicator and acts as follows:
• If the measurement difference does not exceed the maximum
allowed, it updates global arithmetic parameter P299 and the
values assigned to the tool offset selected in the tool table.
It compares the measured value with the theoretical radius assigned
in the table.
• If the maximum wear allowed is exceeded, it sets the "expired tool"
indicator and acts as follows:
• If the measurement difference does not exceed the maximum
allowed, it updates global arithmetic parameter P298 and the
values assigned to the tool offset selected in the tool table.
if it requested the dimension of each edge (parameter "N"), the lengths
will be assigned to global arithmetic parameters from P271 on and the
radii to global arithmetic parameters from P251 on.
C0 It issues a "rejected tool" message and interrupts the
execution so the user may select another tool.
C1 The cycle replaces the tool with another one of the same
family.
P299 Measured length - theoretical length (L).
L Theoretical length (it maintains the previous value).
LW Measured length - theoretical length (L).
C0 It issues a "rejected tool" message and interrupts the
execution so the user may select another tool.
C1 The cycle replaces the tool with another one of the same
family.
P298 Measured radius - theoretical radius (R).
R Theoretical radius (it maintains the previous value).
RW Measured radius - theoretical radius (R).
To Next Page
Loading...
