Programming manual
522
CNC 8070
16.
PROBING CANNED CYCLES.
Probe calibration
(SOFT V02.0X)
498
Programming
The programming format for this cycle is:
#PROBE 2 X Y Z B J E H F
Basic operation
1. Approach movement.
Probe's rapid movement (G00) from the cycle calling point to the
center of the hole.
The approach movement is made in two stages:
·1· Movement in the main work plane.
·2· Movement along the longitudinal axis.
X Real hole center coordinate along the abscissa axis.
Y Real hole center coordinate along the ordinate axis.
Z Real hole center coordinate along the axis perpendicular to
the plane.
B Safety distance. It must be programmed with a positive value
greater than 0.
J Real diameter of the hole. It must be programmed with a
positive value greater than 0.
E Distance the probe withdrawals after the first probing
movement. It must be programmed with a positive value
greater than 0.
H Feedrate for the first probing movement.
F Probing feedrate.
To Next Page
Loading...
