Programming manual
CNC 8070
PROBING CANNED CYCLES.
Surface measuring canned cycle
16.
(SOFT V02.0X)
503
2. Probing movement.
Probing movement along the selected axis (K) at the indicated
feedrate (F) until the probe signal is received.
The maximum probing distance is 2B. If once this distance has
been reached, the CNC has not yet received the probe signal, it
will issue the relevant error code and stop the movement of the
axes.
Once probing is over, the CNC will assume the actual position of
the axes when the probe signal is received as their theoretical
position.
3. Withdrawal movement.
Rapid probe movement (G00) from the probing point to the cycle
calling point.
The withdrawal movement is made in three stages:
·1· Movement to the approach point along the probing axis.
·2· Movement along the longitudinal axis up to the coordinate of the
cycle calling point along that axis.
·3· When programming (C0), it makes a movement in the main
work plane to the cycle calling point.
To Next Page
Loading...
