Programming manual
CNC 8070
PROBING CANNED CYCLES.
Outside corner measuring canned cycle
16.
(SOFT V02.0X)
505
Result of the measurement
Once the cycle has ended, the CNC returns the real values obtained
in the measurement to the following general arithmetic parameters:
Basic operation
1. Approach movement.
Rapid probe movement (G00) from the cycle calling point to the
first approach point located at a (B) distance from the side to be
probed.
The approach movement is made in two stages:
·1· Movement in the main work plane.
·2· Movement along the longitudinal axis.
2. Probing movement.
Probing movement along the abscissa axis at the indicated
feedrate (F) until the probe signal is received.
The maximum probing distance is 2B. If once this distance has
been reached, the CNC has not yet received the probe signal, it
will issue the relevant error code and stop the movement of the
axes.
3. Withdrawal movement.
Rapid probe movement (G00) from the probing point to the first
approach point.
P296 Real coordinate of the corner along the abscissa axis
P297 Real coordinate of the corner along the ordinate axis.
P298 Error detected along the abscissa axis. Difference between
the actual corner coordinate ant the programmed
theoretical coordinate.
P299 Error detected along the ordinate axis. Difference between
the actual corner coordinate ant the programmed
theoretical coordinate.
To Next Page
Loading...
