Programming manual
CNC 8070
PROBING CANNED CYCLES.
Angle measuring canned cycle
16.
(SOFT V02.0X)
511
Result of the measurement
Once the cycle has ended, the CNC returns the real value obtained
in the measurement to the following general arithmetic parameter:
Basic operation
1. Approach movement.
Rapid probe movement (G00) from the cycle calling point to the
first approach point located at a (B) distance from the programmed
vertex and at (2B) from the side to be probed.
The approach movement is made in two stages:
·1· Movement in the main work plane.
·2· Movement along the longitudinal axis.
2. Probing movement.
Probing movement along the ordinate axis at the indicated
feedrate (F) until the probe signal is received.
The maximum probing distance is 3B. If once this distance has
been reached, the CNC has not yet received the probe signal, it
will issue the relevant error code and stop the movement of the
axes.
3. Withdrawal movement.
Rapid probe movement (G00) from the probing point to the first
approach point.
4. Second approach movement.
Rapid probe move (G00) from the first approach point to the
second. It is located at a (B) distance from the first one.
P295 Inclination angle of the part with respect to the abscissa
axis.
To Next Page
Loading...
