Programming manual
CNC 8070
PROBING CANNED CYCLES.
Outside corner and angle measuring canned cycle
16.
(SOFT V02.0X)
515
3. Withdrawal movement.
Rapid probe movement (G00) from the probing point to the first
approach point.
4. Second approach movement.
Rapid probe movement (G00) from the first approach point to the
second, located at a (2B) distance from the second side to be
probed.
This approach movement is made in two stages:
·1· Movement along the ordinate axis.
·2· Movement along the abscissa axis.
5. Second probing movement.
Probing movement along the ordinate axis at the indicated
feedrate (F) until the probe signal is received.
The maximum probing distance is 3B. If once this distance has
been reached, the CNC has not yet received the probe signal, it
will issue the relevant error code and stop the movement of the
axes.
6. Withdrawal movement.
Rapid probe movement (G00) from the probing point to the second
approach point.
7. Third approach movement.
Rapid probe move (G00) from the second approach point to the
third. It is located at a (B) distance from the previous one.
8. Third probing movement.
Probing movement along the ordinate axis at the indicated
feedrate (F) until the probe signal is received.
The maximum probing distance is (4B), if once this distance has
been reached the CNC has not yet received the probe signal, it will
display the relevant error code and stop the movement of the axes.
9. Withdrawal movement.
Rapid probe movement (G00) from the third probing point to the
cycle calling point.
The withdrawal movement is made in three stages:
·1· Movement to the third approach point along the probing axis.
·2· Movement along the longitudinal axis up to the coordinate of the
cycle calling point along that axis.
·3· Movement in the main work plane up to the cycle calling point.
To Next Page
Loading...
