Programming manual
CNC 8070
PROBING CANNED CYCLES.
Hole measuring canned cycle
16.
(SOFT V02.0X)
517
Result of the measurement
Once the cycle has ended, the CNC returns the real values obtained
in the measurement to the following general arithmetic parameters:
Basic operation
1. Approach movement.
Probe's rapid movement (G00) from the cycle calling point to the
center of the hole.
The approach movement is made in two stages:
·1· Movement in the main work plane.
·2· Movement along the longitudinal axis.
P294 Hole diameter.
P295 Hole diameter error. Difference between the real and the
programmed diameters.
P296 Real center coordinate along the abscissa axis
P297 Real center coordinate along the ordinate axis.
P298 Error detected along the abscissa axis. Difference between
the actual center coordinate and the programmed
theoretical coordinate.
P299 Error detected along the ordinate axis. Difference between
the actual center coordinate and the programmed
theoretical coordinate.
To Next Page
Loading...
