Programming manual
CNC 8070
COORDINATE SYSTEM
Programming in radius (G152) or in diameters (G151)
3.
(SOFT V02.0X)
37
3.4 Programming in radius (G152) or in diameters (G151)
Programming in radius or diameters may be selected by program with
these functions:
G151 Programming in diameters.
G152 Programming in radius.
These functions may be programmed anywhere in the program and
they don't have to go alone in the block.
Operation
After executing one of these functions, the CNC assumes that
programming mode for the following blocks.
When switching programming modes, the CNC changes the way it
displays the coordinates of the corresponding axes.
Properties of the function
Functions G151 and G152 are modal and incompatible with each
other.
On power-up, after executing an M02 or M30, and after an
EMERGENCY or RESET, the CNC assumes function G151 if
machine parameter DIAMPROG of any of the axes is set to YES.
The following functions are oriented to lathe type machines.
Programming in diameters is only available on the axes allowed by the
machine manufacturer (DIAMPROG=YES).
i
Programming in radius. Programming in diameters.
To Next Page
Loading...
