Programming manual
88
CNC 8070
5.
TECHNOLOGICAL FUNCTIONS
Feedrate related functions
(SOFT V02.0X)
64
5.2.5 Acceleration control (G130/G131)
These functions allow to change the acceleration and deceleration of
the axes.
Programming
The functions related to acceleration control are:
G130 Percentage of acceleration to be applied per axis.
G131 Percentage of acceleration to be applied, global.
G130 Percentage of acceleration to be applied per axis
The percentaje of aceleration to be applied per axis is set by G130
followed by the axes and the percentage to be applied to each axis.
The acceleration values to be applied must be integers (not decimals).
G131 Percentage of acceleration to be applied, global
The percentaje of aceleration to be applied to all the axes is set by
G131 followed by the new acceleration value to be applied to all the
axes.
The acceleration values to be applied must be integers (not decimals).
When added to a motion block, the new values will be assumed before
executing the move.
a
0
: Nominal acceleration, set by the machine manufacturer.
a
P
: Acceleration to be applied, set by the operator.
...
G00 X0 Y0
G01 X100 Y100 F600
G130 X50 Y20 (Acceleration on the X axis = 50%)
(Acceleration on the Y axis = 20%)
G01 X0
G01 Y0
G131 100 X50 Y80 (Restore 100% of acceleration on all the axes)
(Movement to point X=50 Y=80)
...
To Next Page
Loading...
