Programming manual
CNC 8070
TECHNOLOGICAL FUNCTIONS
Feedrate related functions
5.
(SOFT V02.0X)
65
Considerations
The #SLOPE instruction determines the influence of the values
defined with these values.
• In rapid positioning (G00)
• In the acceleration or deceleration stage.
• In the jerk of the acceleration or deceleration stages.
The programmed percentages are absolute, in other words,
programming a 50% twice means that 50% will be applied, not 25%.
Properties of the functions
Functions G130 and G131 are modal and incompatible with each
other.
On power-up, after an M02, M30, EMERGENCY or a RESET, the CNC
restores 100% of acceleration for all the axes.
To Next Page
Loading...
