Quick reference
(S
OFT 03.1X)
9
Block search
This option may ver used to resume the execution of a program from the point where it was interrupted or aborted.
The CNC shows the options available for selecting the stop condition.
It returns to the main menu.
• Stop block:
It sets as the last block for program history recovery the one currently selected with the cursor.
• To select a subroutine from the list:
Select the folder containing the subroutine.
Select the program containing the subroutine or write its name in the bottom window.
Press [ENTER] to open the program.
Press [ESC] to cancel the selection and close the list of programs.
• Number of times:
It sets as stop condition, that the block selected as the stop block has been executed a specific number of times.
Enter the number of times.
Press [ENTER] to accept the value.
Press [ESC] to reject the value.
• Automatic search:
With this option, it is possible to recover the program history up to the block where the execution was interrupted.
• Starting block:
It establishes the block currently selected with the cursor as the first block of the block search.
There are two ways to select the block:
• Using the cursor
• Using the options "Text search" or "go to line" of the softkey menu.
ENTER
ESC
ENTER
ESC
To Next Page
Loading...
