Quick reference
(S
OFT 03.1X)
11
LIST OF "G" FUNCTIONS
M The function is modal.
D By default, this function is active
?: The initial value depends on the machine parameter.
V This function is displayed in the G-code history.
Function M D V Meaning
G00 * ? * Rapid traverse
G01 * ? * Linear interpolation
G02 * * Clockwise circular (helical) interpolation
G03 * * Counterclockwise circular (helical) interpolation
G04 * Dwell
G05 * ? * Controlled corner rounding (modal)
G06 * Arc center in absolute coordinates (not modal)
G07 * ? * Square corner (modal)
G08 * Arc tangent to previous path
G09 * Arc defined by three points
G10 * * Mirror image cancellation
G11 * * Mirror image on the first axis of the channel
G12 * * Mirror image on the second axis of the channel
G13 * * Mirror image on the third axis of the channel
G14 * * Mirror image in the programmed directions
G17 * ? * Main plane X-Y, and longitudinal axis Z
G18 * ? * Main plane Z-X, and longitudinal axis Y
G19 * * Main plane Y-Z, and longitudinal axis X
G20 * * Main plane by two directions and longitudinal axis
G30 Polar origin preset
G33 * * Electronic threading with constant pitch
G36 * Automatic radius blend
G37 * Tangential entry
G38 * Tangential exit
G39 * Automatic chamfer blend
G40 * * Cancellation of tool radius compensation
G41 * * Left-hand tool radius compensation
G42 * * Right-hand tool radius compensation
G45 * * Activating / deactivating tangential control.
G50 * ? Semi-rounded corner
G53 * Zero offset cancellation
G54 ! * Absolute zero offset 1
G55 ! * Absolute zero offset 2
G57 ! * Absolute zero offset 4
G58 ! * Absolute zero offset 5
G59 ! * Absolute zero offset 6
G60 * Square corner (not modal)
G61 * Controlled corner rounding (not modal)
To Next Page
Loading...
