Quick reference
12
(SOFT 03.1X)
G63 * * Rigid tapping
G70 * ? * Programming in inches
G71 * ? Programming in millimeters
G72 * Scaling factor
G73 * * Coordinate system rotation (pattern rotation)
G74 * Home search
G90 * ? Programming in absolute coordinates
G91 * ? * Programming in incremental coordinates
G92 ! * Coordinate preset
G93 * * Machining time in seconds
G94 * ? Feedrate in millimeters/minute (inches/minute)
G95 * ? * Feedrate in millimeters/revolution (inches/revolution)
G96 * * Constant surface speed
G97 * * Constant turning speed
G100 * Probing
G101 * Include probe offset
G102 * Exclude probe offset
G108 * * Feedrate blending at the beginning of the block
G109 * Feedrate blending at the end of the block
G112 * Changing of parameter range of an axis
G130 * * Percentage of acceleration to be applied per axis
G131 * * Percentage of acceleration to be applied to all the axes
G132 * * Percentage of jerk to be applied per axis
G133 * * Percentage of jerk to be applied to all the axes
G134 * * Percentage of Feed-Forward to be applied
G135 * * Percentage of AC-Forward to be applied
G136 * ? * Circular transition between blocks
G137 * ? Linear transition between blocks
G138 * * Direct activation/cancellation of tool compensation
G139 * * Indirect activation/cancellation of tool compensation
G145 * * Freezes/resumes tangential control
G151 * * * Programming in diameters
G152 * Programming in radius
G157 * * Excluding axes in the zero offset
G158 * * Incremental zero offset
G159 ! * Additional absolute zero offsets
G170 * Hirth axes OFF
G171 * * Hirth axes ON
G18x * OEM subroutines
G192 * * Turning speed limit in constant surface speed mode
G193 * Interpolating the feedrate
G196 * * Constant cutting point feedrate
G197 * * Constant tool center feedrate
G198 * Setting of lower software travel limits
G199 * Setting of upper software travel limits
Function M D V Meaning
To Next Page
Loading...
