Fagor CNC 8070 - Page 19

 Quick reference
17
(SOFT 03.1X)
G86. Boring canned cycle
G86 Z I K R
Z Reference plane.
I Boring depth.
K
Delay, in seconds, between the boring and the
withdrawal movement.
R Type of withdrawal:
• "R"=0: in rapid (G00).
• "R"=1: At work feedrate (G01).
G87. Rectangular pocket canned cycle.
G87 Z I D A J K M Q B C L H V
Z Reference plane.
I Pocket depth.
D
Distance between the reference plane and the part
surface.
A
Angle, in degrees, between the pocket and the
abscissa axis.
J Half length of the pocket.
K Half width of the pocket.
M Type of corner:
• "M"=0: square
• "M"=1: rounded
• "M"=2: chamfer.
Q Rounding radius or chamfer size.
B Depth of pass.
C Milling pass or width.
L Finishing pass.
H Feedrate for the finishing pass.
V Tool penetrating feedrate.
G88. Circular pocket canned cycle
G88 Z I D J B C L H V
Z Reference plane.
I Pocket depth.
D
Distance between the reference plane and the part
surface.
J Pocket radius.
B Depth of pass.
C Milling pass or width.
L Finishing pass.
H Feedrate for the finishing pass.
V Tool penetrating feedrate.
G90
Z
I
Zi
Z
I
G91
Zi
Z (G90)
I (G90)
I (G91)
Z (G91)
J
D
B
(X,Y)
K
A
Zi
Z (G90)
I (G90)
I (G91)
Z (G91)
(X,Y)
J
D
B