Fagor CNC 8070 - Warranty on Repairs

 Quick reference
26
(SOFT 03.1X)
#PROBE 3. Surface measuring
#PROBE 3 X Y Z B <K> F <C> <L> <T D>
K Axis used to measure the surface:
• "K"=0: probing with the abscissa axis.
• "K"=1: probing with the ordinate axis.
• "K"=2: probing with the axis perpendicular to the
plane.
F Probing feedrate.
C Point where the probing cycle ends.
• "C"=0: the probe returns to the point from where
the cycle was called.
• "C"=1: the cycle ends with the probe positioned
over the measured point.
L Tolerance for the measuring error.
X..Z Theoretical coordinates of the probing point. T Tool whose wear is to be corrected.
B Safety distance. D Offset whose wear is to be corrected.
#PROBE 4. Outside corner measuring
#PROBE 4 X Y Z B F
X..Z Theoretical coordinates corner being measured.
B Safety distance.
F Probing feedrate.
#PROBE 5. Inside corner measuring
#PROBE 5 X Y Z B F
X..Z Theoretical coordinates corner being measured.
B Safety distance.
F Probing feedrate.
Z
X
Y
XYZ
B
B
B
B
B
B
B
B
B
B