Quick reference
27
(SOFT 03.1X)
#PROBE 6. Measuring the angle with the abscissa axis
#PROBE 6 Z Y Z B F
X..Z Theoretical coordinates corner being measured.
B Safety distance.
F Probing feedrate.
#PROBE 7. Outside corner and angle measuring
#PROBE 7 X Y Z B F
X..Z Theoretical coordinates corner being measured.
B Safety distance.
F Probing feedrate.
#PROBE 8. Hole measuring
#PROBE 8 X Y Z B J E <C> H F
X..Z Theoretical coordinates of the arc center.
B Safety distance.
J Theoretical hole diameter.
E Withdrawal distance after initial probing.
C Point where the probing cycle ends.
• "C"=0: the probe returns to the point from where
the cycle was called.
• "C"=1: the cycle will finish with the probe at the
real hole center.
H Feedrate for the initial probing movement.
F Probing feedrate.
2B
B
B
B
2B
B
B
B
2B
2B
2B
XYZ
B
E
B
J
To Next Page
Loading...
