Quick reference
32
(SOFT 03.1X)
MULTIPLE MACHINING (MILLING)
Note:
Parameters P, Q, R, S, T, U and V are optional parameters that may be used in any type of multiple
positioning. These parameters indicate in which points or between which points of the ones programmed
the machining is NOT to be carried out.
G160. Multiple machining in straight line
G160 A X I P Q R S T U V
A
Angle, in degrees of the machining path with respect to the
abscissa axis.
X K
I K X Length of the machining path.
I Step between machining operations.
K
Total number of machining operations in the section,
including that of the machining definition point.
G161. Multiple machining in rectangular pattern
G161 A B X I Y J P Q R S T U V
A
Angle, in degrees of the machining path with respect to the
abscissa axis.
X K Y D
I K J D B Angle between both machining paths.
X Length of the parallelogram.
I Step between machining operations along the path.
K
Total number of machining operations along the path,
including that of the machining definition point.
Y Width of the parallelogram.
J Step between machining operations along the path.
D
Total number of machining operations along the path,
including that of the machining definition point.
To Next Page
Loading...
