Quick reference
33
(SOFT 03.1X)
G162. Multiple machining in grid pattern
G162 A B X I Y J P Q R S T U V
A
Angle, in degrees of the machining path with respect to the
abscissa axis.
X K Y D
I K J D B Angle between both machining paths.
X Length of the drid.
I Step between machining operations along the path.
K
Total number of machining operations along the path,
including that of the machining definition point.
Y Width of the drid.
J Step between machining operations along the path.
D
Total number of machining operations along the path,
including that of the machining definition point.
G163. Multiple machining in a full circle
G163 X Y I C F P Q R S T U V
X
Distance from the starting point to the center along the
abscissa axis.
K
Y
Distance from the starting point to the center along the
ordinate axis.
I Angular step between machining operations.
K
Total number of machining operations including that of the
machining definition point.
C It indicates how it will move between the machining points.
• "C"=0: In rapid (G00).
• "C"=1: Linear interpolation (G01).
• "C"=2: In clockwise circular interpolation (G02).
• "C"=3: In counterclockwise circular interpolation (G03).
F
Feedrate for the movement between points. Only if C is other
than 0.
To Next Page
Loading...
