Hardware configuration.
CNC 8070
6.
CENTRAL UNIT + MONITOR (Q7-A PLATFORM).
Enclosure and securing of the modules.
·102·
(REF: 1911)
6.3.3 Securing the module.
The module must be installed in a proper enclosure that may be located on the machine or
on an external support. To insert the unit into the enclosure, it must have a big enough hole
to allow to insert it easily, without obstacles and without forcing the unit.
The module is secured from the inside of the enclosure; therefore, there is no need to drill
any holes on the front. Once the unit has been inserted into the enclosure, secure it from
the inside with the tension jacks. To properly secure it, use all the tension jacks on the back
of the unit. Apply a tightening torque of 0.7 Nm.
To Next Page
Loading...
