Fagor CNC 8070 - Setting the feedrate and spindle speed.

Hardware configuration.
CNC 8070
6.
CENTRAL UNIT + MONITOR (Q7-A PLATFORM).
Hardware functionality (connectors).
·108·
(REF: 1911)
·A22· 24 V DC supply input.
·B28· CAN bus.
·B32· Sercos II bus.
Connector data.
Number of poles. 3.
Pitch. 5,08 mm.
Connection technique. Screw connection.
Minimum/maximum tightening torque. 0.5 / 0.6 Nm.
Minimum/maximum section. 0.2 / 2.5 mm².
Minimum/maximum AWG section. 24 / 12.
Rated current In. 12 A.
Cable data.
Length to be stripped. 7 mm.
See "6.4 Power supply for the module." on page 103.
Connector data.
Number of poles. 5.
Pitch. 3.5 mm.
Connection technique. Screw connection.
Minimum/maximum tightening torque. 0.22 / 0.25 Nm.
Minimum/maximum section. 0.14 / 1.5 mm².
Minimum/maximum AWG section. 28 / 16.
Rated current In. 8 A.
Cable data.
Length to be stripped. 7 mm.
See "6.8.11 CAN bus." on page 131.
Plug-in part. 3-pole Phoenix-contact combicon connector (5.08 mm
pitch).
Pin Signal. Function.
1 - - -.
2 GND 0 V reference signal.
3 +24 V Power supply.
Plug-in part. 5-pole Phoenix-contact minicombicon connector (3.5 mm
pitch).
Pin. Signal. Function.
1 GND Ground / 0 V.
2 CL (LOW) bus signal.
3 SH CAN shield.
4 CH (HIGH) bus signal.
5 SH CAN shield.
Sercos emitter and receiver.
Signal. Function.
IN Sercos signal receiver.
OUT Sercos signal emitter.
See "6.8.12 Sercos II bus." on page 134.
IN
OUT