Fagor CNC 8070 - Working in the editing window.

Hardware configuration.
CNC 8070
7.
CENTRAL UNIT FOR CABINET (Q7-A PLATFORM).
Hardware functionality (connectors).
·148·
(REF: 1911)
7.6.4 Connector identification.
·A22· 24 V DC supply input.
·B28· CAN bus.
·B32· Sercos II bus.
All the equipment connectors are polarized (they can only be connected in one sense) and those that
are exactly the same are also coded by coding pins to prevent incorrect or accidental connection,
respectively.
i
Connector data.
Number of poles. 3.
Pitch. 5.08 mm.
Connection technique. Screw connection.
Minimum/maximum tightening torque. 0.5 / 0.6 Nm.
Minimum/maximum section. 0.2 / 2.5 mm².
Minimum/maximum AWG section. 24 / 12.
Rated current In. 12 A.
Cable data.
Length to be stripped. 7 mm.
See "7.4 Power supply for the module." on page 142.
Connector data.
Number of poles. 5.
Pitch. 3.5 mm.
Connection technique. Screw connection.
Minimum/maximum tightening torque. 0.22 / 0.25 Nm.
Minimum/maximum section. 0.14 / 1.5 mm².
Minimum/maximum AWG section. 28 / 16.
Rated current In. 8 A.
Cable data.
Length to be stripped. 7 mm.
See "7.8.10 CAN bus." on page 172.
Plug-in part. 3-pole Phoenix-contact combicon connector (5.08 mm
pitch).
Pin Signal. Function.
1 - - -.
2 GND 0 V reference signal.
3 +24 V Power supply.
Plug-in part. 5-pole Phoenix-contact minicombicon connector (3.5 mm
pitch).
Pin. Signal. Function.
1 GND Ground / 0 V.
2 CL (LOW) bus signal.
3 SH CAN shield.
4 CH (HIGH) bus signal.
5 SH CAN shield.
Sercos-II emitter and receiver.
Signal. Function.
IN Sercos signal receiver.
OUT Sercos signal emitter.
See "7.8.9 Bus Sercos-II." on page 169.