Hardware configuration.
CNC 8070
CENTRAL UNIT FOR CABINET (Q7-A PLATFORM).
7.
Hardware functionality (connectors).
·153·
(REF: 1911)
·I24· Local digital outputs (8 outputs).
Connector data.
Number of poles. 6.
Pitch. 2.5 mm.
Connection technique. Spring connection.
Minimum/maximum section. 0.14 / 0.5 mm².
Minimum/maximum AWG section. 26 / 20.
Rated current In. 4 A.
Cable data.
Length to be stripped. 8 mm.
See "7.7.2 Digital outputs." on page 156.
Left connector.
Pin 1 coded.
Right connector.
Pin 6 coded.
Plug-in part. Two coded connectors. 6-pole Phoenix-contact
minicombicon connector (2.5 mm pitch).
• Left connector. Pin 1 coded.
• Right connector. Pin 6 coded.
• Both connectors.
Pin. Signal. Function.
1
24 V 24 V DC voltage supply.
2-3 LO1 - LO2 Local digital outputs. In the laser model, use
these pins for PWM and synchronous
switching.
4-5 LO3 - LO4 Local digital outputs.
6 GND 0 V reference signal.
Pin. Signal. Function.
1
24 V 24 V DC voltage supply.
2- 5 LO5 - LO8 Local digital outputs.
6 GND 0 V reference signal.
The PWM and synchronized switching options can only use pin 2 (LO1) and pin 3 (LO2) on the left
connector.
To Next Page
Loading...
