Fagor CNC 8070 - Page 154

Hardware configuration.
CNC 8070
7.
CENTRAL UNIT FOR CABINET (Q7-A PLATFORM).
Hardware functionality (connectors).
·154·
(REF: 1911)
·I25· Probe input.
·I26· General purpose ±10 V analog output (16 bits).
Connector data.
Number of poles. 5.
Pitch. 3.5 mm.
Connection technique. Screw connection.
Minimum/maximum tightening torque. 0.22 / 0.25 Nm.
Minimum/maximum section. 0.14 / 1.5 mm².
Minimum/maximum AWG section. 28 / 16.
Rated current In. 8 A.
Cable data.
Length to be stripped. 7 mm.
See "7.8.6 Probe connection." on page 162.
Connector data.
Number of poles. 3.
Pitch. 3.5 mm.
Connection technique. Screw connection.
Minimum/maximum tightening torque. 0.22 / 0.25 Nm.
Minimum/maximum section. 0.14 / 1.5 mm².
Minimum/maximum AWG section. 28 / 16.
Rated current In. 8 A.
Cable data.
Length to be stripped. 7 mm.
Plug-in part. 8-pole Phoenix-contact minicombicon connector (3.5 mm
pitch).
Pin. Signal. Description.
1 GND_5V 0 V reference signal for 5V.
2 +5 V 5 V output.
3 PRB1_IN5V 5 V input of probe 1.
4 PRB2_IN5V 5 V input of probe 2.
5 PRB1_IN24V 24 V input of probe 1.
6 PRB2_IN24V 24 V input of probe 2.
7 GND_24V 0 V reference signal for 24 V.
8 Chassis Shield.
Plug-in part. 3-pole Phoenix-contact minicombicon connector (3.5 mm
pitch).
Pin Signal. Function.
1 GND 0 V reference signal.
2 AO Analog output.
3 SH Shield.