Hardware configuration.
CNC 8070
CENTRAL UNIT FOR CABINET (Q7-A PLATFORM).
7.
Connections.
·163·
(REF: 1911)
Probe whose output has a normally closed contact. Connection to +24 V.
The connection acts upon the up flank (positive pulse) of the probe signal.
Interface with an open-collector output. Connection to +5 V.
The connection acts upon the down flank (negative pulse) of the probe signal.
Interface with an open-collector output. Connection to +24 V.
The connection acts upon the down flank (negative pulse) of the probe signal.
Interface with a PUSH-PULL output. Connection to +5 V.
Depending on the interface being used, the connection acts upon the up flank or down flank
of the probe signal.
To Next Page
Loading...
