Hardware configuration.
CNC 8070
9.
MONITOR-21 MULTITOUCH.
Connectors.
·194·
(REF: 1911)
9.7 Connectors.
·T/S RS232· Touch screen driver (not recommended).
·T/S USB· Touch screen driver (recommended).
Option recommended by Fagor Automation for the touch controller.
Bottom view.
(1) T/S RS-232Touch screen driver (consult Fagor Automation).
(2) T/S USBTouch screen driver (recommended).
(3) 24 V DC IN24 V DC supply input (recommended).
(4) 12 V DC IN12 V DC supply input (consult Fagor Automation).
(5) DVI-DDVI-D video signal input.
(6) VGAVGA video signal input.
(7) Ground connection.
Ground connection.
A B C D E F
G
Plug-in part 9-pin female SUB-D HD connector.
Pin. Signal. Function.
1 DCD Data Carrier Detect.
2 RxD Received Data.
3 TxD Transmit Data.
4 DTR Data Terminal Ready.
5 GND Ground.
6 DSR Data Set Ready.
7 RTS Request To Send.
8 CTS Clear To Send.
9 RI Ring Indicator.
1 ... 5
6 ... 9
Touch controller.
Fagor Automation recommends using the USB driver for the touch screen. Consult Fagor Automation
before using the RS232 driver.
USB type-B controller. Plug-in part.
Maximum length; 5 m (16.40 feet).
Pin. Signal.
1+ 5 V DC.
2 Data -.
3 Data +.
4 GND.
1
2
4
3
Using cables with a length longer than 5 m or extension cords can cause problems in terms of
compliance with EMC directives; before using this type of cables in an industrial setting, check whether
the installation complies with regulations.
To Next Page
Loading...
