Fagor CNC 8070 - Real coordinates; Real coordinates with enlarged error; Simulation speed

Hardware configuration.
CNC 8070
MONITOR-21 MULTITOUCH.
9.
Cable characteristics.
·197·
(REF: 1911)
9.8 Cable characteristics.
9.8.1 VGA video signal.
Connector pinout.
Cable characteristics.
Use specific VGA cable.
Node connection.
Use the VGA output of the central unit. The connection is parallel, 1 with 1, 2 with 2, etc. The
cable shield must be connected to the connector at both ends.
Fagor Automation supplies the necessary cable for the VGA connection. The cable is valid for static
installations such as cable carrying chains. For further information, refer to the Ordering Handbook.
·VGA· cable.
Type. Shielded.
Flexibility. Normal.
Impedance. 75.
Maximum length. 5 m (16.40 ft).
Plug-in part 15-pin female SUB-D HD type connector.
Pin. Signal.
1MAINS
2 GREEN
3BLUE
4- - -
5GND
6 GND_RED
7 GND_GREEN
8 GND_BLUE
9- - -
10 GND_SYNC
11 - - -
12 - - -
13 HSYNC
14 VSYNC
15 - - -
1 ... 5
11 ... 15
Consult Fagor Automation before using cables longer than 5 m.
i
GND
BLUE
GREEN
GND_SYNC
GND_BLUE
GND_GREEN
GND_RED
Housing
Housing
1
CNC MONITOR
RED
HSYNC
VSYNC
GND
BLUE
GREEN
GND_SYNC
GND_BLUE
GND_GREEN
GND_RED
RED
HSYNC
VSYNC
2
3
5
6
7
8
10
13
14
1
2
3
5
6
7
8
10
13
14