Fagor CNC 8070 - Type of graphics

Hardware configuration.
CNC 8070
HORIZONTAL KEYB / HORIZONTAL KEYB+MOUSE.
10.
Hardware functionalities.
·211·
(REF: 1911)
10.6 Hardware functionalities.
10.6.1 Ground connection.
10.6.2 Rear connectors.
It is up to the system integrator to meet all the requirements of local and national electrical codes as
well as all the regulations applicable regarding the grounding of the whole unit.
(A) 24 V DC voltage supply.
(B) CAN bus.
(C) Bus switch and transmission speed.
(D) Address (node) of the element.
(E) Line terminating resistor.
(F) Keys of a passive monitor.
Ground connection.
AB
C
D
E
F
B