Fagor CNC 8070 - 13.6 Hardware functionalities.; 13.6.1 Ground connection.; 13.6.2 Rear connectors.

Hardware configuration.
CNC 8070
OP-PANEL / OP-PANEL+SPDL RATE.
13.
Hardware functionalities.
·245·
(REF: 1911)
13.6 Hardware functionalities.
13.6.1 Ground connection.
13.6.2 Rear connectors.
It is up to the system integrator to meet all the requirements of local and national electrical codes as
well as all the regulations applicable regarding the grounding of the whole unit.
(A) 24 V DC voltage supply.
(B) Handwheels.
(C) CAN bus.
(D) Bus switch and transmission speed (CANopen).
(E) Address (node) of the element.
(F) Line terminating resistor.
(G) ERR led, transmission status indicator.
(H) RUN led, module status indicator.
Ground connection.
A
H
G
B
C
D
E
F
C