Hardware configuration.
CNC 8070
CONFIGURATION.
2.
Central unit + Monitor + Keyboard and Operator panel.
·31·
(REF: 1911)
2.5 Central unit + Monitor + Keyboard and Operator panel.
The central unit is located on the rear of the monitor.
2.6 Operator panels.
2.7 USB keyboard.
Identification. Description.
C70-10K
• Central unit.
• 10.4" LCD monitor (800x600) 18-bit color.
• Built-in keyboard.
• Built-in operator panel.
• USB 2.0 port, at the front, protected by a
cover.
Identification. Description.
OP-PANEL
Available for all models.
• Length 420 mm (16.54")
• 16 configurable user keys.
• Jog switch (0 - 200 %).
• 15 configurable jog keys.
• CNC power-down key.
• CAN communication (CANopen protocol).
• Spindle override key.
• Possibility to connect up to three
handwheels.
OP-PANEL+SPDL RATE
Available for all models.
• Length 420 mm (16.54")
• 16 configurable user keys.
• Jog switch (0 - 200 %).
• 15 configurable jog keys.
• CNC power-down key.
• CAN communication (CANopen protocol).
• Spindle override switch.
• Possibility to connect up to three
handwheels.
Identification. Description.
HORIZONTAL KEYB 2.0 + TOUCHPAD.
• USB horizontal, alphanumeric QWERTY
keyboard.
• Multi-touch touchpad (touch panel).
• Numeric keypad optimized to operate with
the CNC (keys for axes, feedrate, speed, etc).
• Special functions with the Fagor key.
To Next Page
Loading...
