Fagor CNC 8070 - Page 66

Hardware configuration.
CNC 8070
5.
CENTRAL UNIT + MONITOR (ETX PLATFORM).
Hardware functionality. Connectors.
·66·
(REF: 1911)
Ethernet.
8-pin RJ45 connector and 2 status LED's.
USB ports.
Type A USB double connector.
Mouse with PS-2 connector.
6-pin minidin female connector.
·VGA· connector.
15-pin female SUB-D HD type connector.
13245768
Pin. Signal.
1 TX+ (transmit data).
2 TX- (transmit data).
3 RX+ (receive data).
4- - -
5- - -
6 RX- (receive data).
7- - -
8- - -
LED. Meaning.
Green The LED turns on when the central unit is connected to
network.
Yellow The LED blinks when data is being transferred.
Pin. Signal.
1+ 5 V
2DT -
3DT +
4GND
4
2
3
1
4
2
3
1
No USB devices must be used nor connected while executing a part program. Using USB devices may
slow down the execution or cause some "RT-IT overflow" type error.
USB devices must comply with the generic regulation IEC 61000-6-2:2005 on immunity for industrial
use. We recommend to also comply with the European Directive 2004/108/EC on EMC for industrial
use.
i
Pin. Signal.
1 Mouse data.
2- - -
3GND
4+5 V
5 Mouse clock.
6- - -
1
3
5
2
4
6
Pin. Signal.
1MAINS
2 GREEN
3BLUE
4- - -
5GND
6GND_RED
7GND_GREEN
8 GND_BLUE
Pin. Signal.
9- - -
10 GND_SYNC
11 - - -
12 - - -
13 HSYNC
14 VSYNC
15 - - -
5
1
10
6
15
11