Fagor CNC 8070 - Display the status of the program or of the active subroutines.

Hardware configuration.
CNC 8070
5.
CENTRAL UNIT + MONITOR (ETX PLATFORM).
Hardware functionality. Connectors.
·72·
(REF: 1911)
Power supply.
3-pin male Phoenix-contact combicom connector (7.62 mm pitch).
Connector to power the central unit with universal 24 V DC. See
"5.7 Power supply for the
module."
on page 61.
Protection fuse.
The module has a 5 A fuse that may be accessed from the outside to protect against over-
voltage (greater than 36 V DC or 25 V AC).
Auxiliary 24V output to supply the operator panel.
3-pin male Phoenix-contact minicombicon connector (3.5 mm pitch).
This connector offers the possibility to supply voltage from the central unit to the operator
panel. It is mainly oriented to those configurations where the operator panel is integrated into
the monitor (LCD-10K) or close to it.
·BATTERY· connector . Battery voltage and charge.
5-pin male Phoenix-contact minicombicon connector (3.5 mm pitch).
This connector can also be used to connect an external battery that ensures the proper shut-
down of the unit due to a power failure. The battery provides an autonomy of about 20 minutes
when it is fully charged.
·LATCH· button and status LED's.
When the red LED is on, it means that there is an over-current at the power supply and it
is not running. The ·LATCH· button may be used to reactivate the power supply after an over-
current.
3
2
1
+24 V
GND
Chassis
Signal. Function.
Chassis Shield.
GND Power supply.
+24 V Power supply.
3
2
1
+24 V
GND
Chassis
Signal. Function.
Chassis Shield.
GND Power supply.
+24 V Power supply.
5
4
3
2
1
Vbat -
Vbat +
Chassis
Vch +
Vch -
Signal Function
Vbat -
Vbat +
Central unit powered by the battery.
Chassis Shield.
Vch -
Vch +
Recharging the battery through the central unit.