Fagor CNC 8070 - Rectangular Pocket Canned Cycle

E
XAMPLES MANUAL
Chapter 2
Page 11 of 96
Conversational
programming
Exercise 1. Pockets
CNC 8070
RECTANGULAR POCKET CANNED CYCLE.
GEOMETRY
X Lower left corner in X 84
Y Lower left corner in Y -28
L Length in X 42
H Length in Y 56
Z Surface Z coordinate 0
Zs Safety Z coordinate 2
P Total pocket depth -10
a pocket inclination angle 0
r Corner blending radius
Corner finishing
ROUGHING
∆ Roughing pass 0
IPass in Z 5
Fz Penetrating feedrate at each pass in Z mm/min. 100
β Penetrating angle. 90
F Roughing feedrate in mm/min. 920
S RPM 3180
T Finishing tool number 5
D Tool offset 1
Counterclockwise turning direction
Counterclockwise machining direction