Fagor CNC 8070 - Drilling Canned Cycle

OF 96
E
XAMPLES MANUAL
Conversational
programming
Exercise 1. Pockets
Chapter 2
Page 14 of 96
CNC 8070
DRILLING CANNED CYCLE
Once the form has been filled out, instead of inserting the cycle into the program, you must locate
the drilling positions using the Multiple softkey (F7) that shows the various types of positioning
as described for the previous form and make sure that the points coincide with the ones
previously programmed in the center punching cycle.
GEOMETRY
X X coordinate of the first hole 56
Y Y coordinate of the first hole 0
Z Surface Z coordinate 0
Zs Safety Z coordinate 2
P Total pocket depth -10
MACHINING
I Penetration step 5
B Chip relief distance after each pass I. 2
F Feedrate in mm/min. 920
S Spindle rpm 3180
T Tool number 7
D Tool offset number 1
t Dwell at the bottom (seconds) 1
Counterclockwise turning direction