Fagor CNC 8070 - Precautions Against Product Damage

OF 96
E
XAMPLES MANUAL
Conversational
programming
Exercise 2. 2D
pocket
Chapter 2
Page 18 of 96
CNC 8070
SURFACE MILLING CANNED CYCLE
GEOMETRY
Type of surface milling. Unidirectional surface milling along X
Corner where the surface milling begins. Lower left corner.
X X coordinate of the initial corner -140
Y Y coordinate of the initial corner -80
L Total length in X 280
H Total length in Y 160
Z Height coordinate of the surface 0
Zs Safety Z coordinate 2
P Total surface milling depth -2
α Surface milling angle 0
ROUGHING
∆ Roughing pass 15
E Overshooting for chip relief 25
Fz Penetrating feedrate at each pass (mm/min.) 200
I Penetration step in Z 1
F Machining feedrate in mm/min. 510
SRPM 920
T Number of the tool to be used 1
D Tool offset 1
Counterclockwise turning direction
FINISHING
∆ Finishing pass 0
δz Excess material in Z 0
F Machining feedrate in mm/min. 510
S RPM 920
T Tool number 1
D Tool offset 1
Counterclockwise turning direction