OF 96
E
XAMPLES
MANUAL
Conversational
programming
Exercise 2. 2D
pocket
Chapter 2
Page 20 of 96
CNC 8070
2D POCKET CANNED CYCLE
GEOMETRY
P.2D Name of the 2D pocket profile. Pocket-1
P.XY Name of the depth profile. Profile-2
Z Height coordinate of the surface. 0
Zs Safety Z coordinate. 2
P Total surface milling depth. -20
Without prior drilling.
ROUGHING
∆ Roughing pass. 0
I Penetration step in Z. 5
Fz Penetrating feedrate at each pass (mm/min.) 100
β Penetrating angle. 90
F Machining feedrate in mm/min. 1000
S RPM 3980
T Number of the tool to be used. 2
D Tool offset. 1
Counterclockwise turning direction.
ROUGHING
∆ Finishing pass. 0
δ Finishing stock. 0.5
F Finishing feedrate in mm/min. 100
N Number of finishing passes in Z 1
δz Excess material in Z 0.5
S RPM 3980
T Number of the tool to be used. 2
D Tool offset. 1
θ Tool penetrating angle when finishing 0
Counterclockwise turning direction.
To Next Page
Loading...
