OF 96
E
XAMPLES
MANUAL
Conversational
programming
Exercise 2. 2D
pocket
Chapter 2
Page 22 of 96
CNC 8070
2D POCKET CANNED CYCLE. PROFILE EDITOR
Once located in the relevant P.XY box to name the profile to be used, press the [RECALL] key
to access the profile editor automatically.
Start by making a rectangle delimiting the outside contour of the figure that will request the first
point of the geometry.
RECTANGLE
BEGINNING
X = -150 Y = -90 VALIDATE
Lx = 300 Ly = 180 VALIDATE
NEW PROFILE
BEGINNING
X = 30 Y = -51.96 VALIDATE
COUNTERCLOCKWISE ARC
X = 30 Y = 51.96 Xc = 60 Yc = 0 VALIDATE
CLOCKWISE ARC
X = -30 Y = 51.96 Xc = 0 Yc=103.925 TANGENCY = YES
VALIDATE
COUNTERCLOCKWISE ARC
X = -30 Y = -51.96 Xc = -60 Yc = 0 VALIDATE
CLOCKWISE ARC
X = 30 Y = -51.96 Xc = 0 Yc = -103.925 VALIDATE
END
SAVE PROFILE
Once the profile is completed, finish it with the [END] key and then save it displaying a message
that indicates that the pocket has been saved and returning to the screen that was displayed
before getting into the profile editor.
Once the whole 2D-pocket form has been defined, press the [GENERATE] softkey and [ENTER]
and then [Insert 2D Pocket]
To Next Page
Loading...
