OF 96
E
XAMPLES
MANUAL
Conversational
programming
Exercise 3. Cam
Chapter 2
Page 26 of 96
CNC 8070
2D POCKET CANNED CYCLE
GEOMETRY
P.2D Name of the 2D pocket profile Pocket-1
P.XY Name of the depth-profile file. Profile-1
Z Height coordinate of the surface 0
Zs Safety Z coordinate 2
P Total surface milling depth -10
Without prior drilling
ROUGHING
∆ Roughing pass 0
I Penetration step in Z 5
Fz Penetrating feedrate at each pass (mm/min.) 100
β Penetrating angle 90
F Machining feedrate in mm/min. 1590
SRPM 680
T Number of the tool to be used 2
D Tool offset 1
Counterclockwise turning direction
FINISHING
∆ Finishing pass 0
δ Finishing stock. 0.5
F Finishing feedrate in mm/min. 1590
N Number of finishing passes in Z 1
δz Excess material in Z 0.5
S RPM 680
T Finishing tool number 3
D Tool offset 1
θ Tool penetrating angle when finishing 90
Counterclockwise turning direction
To Next Page
Loading...
