OF 96
E
XAMPLES
MANUAL
Conversational
programming
Exercise 3. Cam
Chapter 2
Page 28 of 96
CNC 8070
2D POCKET CANNED CYCLE. PROFILE EDITOR
Once located in the relevant P.XY box to name the profile to be used, press the [RECALL] key
to access the profile editor automatically.
Start by making a rectangle delimiting the outside contour of the figure that will request the first
point of the geometry.
BEGINNING
RECTANGLE
X = -165 Y = -90 VALIDATE
Lx = 330 Ly = 180 VALIDATE
NEW PROFILE
BEGINNING
X = -139.58 Y = 11,563 VALIDATE
CLOCKWISE ARC
X = -88.761 Y = 66.53 Xc = -112.5 Yc = 37.5 R = 37.5 VALIDATE
COUNTERCLOCKWISE ARC
X = -17.693 Y = 53.395 R = 75 TANGENCY = YESVALIDATE
CLOCKWISE ARC
X = 7.639 Y = 55.729 Xc = 0 Yc = 0 R=56.25
TANGENCY = YES VALIDATE
CLOCKWISE ARC
X = 139.58 Y = -11.563 R = 225 TANGENCY=YES VALIDATE
CLOCKWISE ARC
X = 88.761 Y = -66.53 Xc = 112.5 Yc = -37.5 R = 37.5 VALIDATE
COUNTERCLOCKWISE ARC
X = 17.693 Y = -53.395 R = 75 VALIDATE
CLOCKWISE ARC
X = -7.639 Y = -55.729 Xc = 0 Yc = 0 R=56.25
TANGENCY = YES VALIDATE
CLOCKWISE ARC
X = -139.58 Y = 11.563 R = 225 TANGENCY=YES VALIDATE
END
SAVE PROFILE
Once the profile is completed, finish it with the [END] key and then save it displaying a message
that indicates that the pocket has been saved and returning to the screen that was displayed
before getting into the profile editor.
Once the whole 2D-pocket form has been defined, press the [GENERATE] softkey and [ENTER]
and then [Insert 2D Pocket]
To Next Page
Loading...
