OF 96
E
XAMPLES
MANUAL
Conversational
programming
Exercise 3. Cam
Chapter 2
Page 34 of 96
CNC 8070
At the profile editor, draw the geometry to be emptied. Before beginning to define it, bear in mind
that you're going to machine; therefore, you will have to use a tool with a certain diameter. Pay
attention to the geometry of the drawing so the tool can work inside it since it is an emptying
operation.
• This is the theoretically drawn geometry; but, as may be seen in the drawing, the tool could
never machine the programmed corners because it does not fit. Therefore, the tool must be
given some relief in those four corners.
• For example, this would be the best way to program this profile.
To Next Page
Loading...
